Working with the notebook
Wireless LAN/Bluetooth/UMTS/LTE radio components
The installation of radio components not approved by Fujitsu Technology Solutions
will invalidate the certifications issued for this device.
Switching the wireless components on and off
► Press the key combination
Bluetooth
Bluetooth
WirelessLAN
WirelessLAN
The wireless component indicator will illuminate when one or more wireless
components are switched on.
If you switch off the radio components, the Bluetooth and UMTS/LTE modules and
the wireless LAN transmission unit (antenna) are also switched off.
Pay attention to the additional safety notes for devices with radio components
provided in the "Safety/Regulations" manual.
Details on using a Wireless LAN can be found in the online help system
included in the Wireless LAN software.
You can obtain more information on UMTS from your service provider.
Setting up WLAN access
•
Requirement: A WLAN must be available and you must have the
corresponding access information.
Information on configuring the WLAN access can be found in the
documentation for your operating system.
Access via UMTS/LTE
You can purchase the accessories for UMTS/LTE reception from your retailer
or your Fujitsu Technology Solutions dealer.
If you have ordered a UMTS/LTE module, your device will already
be prepared when you receive it.
You will find information on establishing the connection with the UMTS/LTE
network in the documentation for the hardware you plan to use.
Your device can connect with the Internet via UMTS/LTE. To do this, use one
of the following types of connection:
•
USB dongle
a USB stick with your mobile phone provider's SIM card
•
a mobile end-device (e.g. mobile phone) with Bluetooth connection
•
a mobile end-device (e.g. mobile phone) with data cable
36
Fn
+
F5
to start the WirelessSelector.
Fujitsu