Tanaka MOBY XL Service Manual page 14

Service Manual
Moby XL, SE-803
Engine Repair Cont.
Electrical Systems cont.
Remove the flywheel (refer to page 11 for disassembly procedure),
and inspect the integrity of the flywheel keyway, the crankshaft
keyway and the key itself. Any deformation of the key or keyways will
require replacement of those components.
After identifying the integrity of the coil (refer to page 8 for coil testing
procedure), or replacing it with a new one, check the air gap between
the coil and flywheel (A).
Gap should be measured with a feeler gauge and set at 0.014".
FUEL SYSTEM
The fuel system consists of the carburetor (1), fuel tank (2), fuel
supply line (3), fuel return line (4), fuel filter and fuel tank vent (5).
The carburetor is held in place between the air cleaner body and the
heat insulator block with two screws that are accessed on the
exterior of the cleaner body (with the cover and cleaner element
removed).
After removing the carburetor, inspect the gasket that mounts
between the carburetor and insulator block. Often times a
compromised gasket will show signs that it has allowed fuel to
escape. Replace all mounting gaskets when servicing the carburetor.
Fuel System cont.
www.tanaka-usa.com 12 custsvc@tanaka-ism.com