Axis 2120 User Manual page 43

AXIS 2120 User's Manual
Installation and Configuration Overview
Configure the AXIS 2120 to upload images to an Internet Service Provider in Alarm Mode, as
follows:
1. Connect the AXIS 2120 to the network if available. Otherwise, use the supplied Null Modem Cable. Connect a computer
and initiate a dial-up connection to the AXIS 2120. For this and general information on the dial-up connection, refer to
Installing Your Camera to a Modem on page 19.
2. Create a dedicated dial-up connection.
3. Refine the dial-up parameters.
4. Initiate the dial-up connection.
5. Referring to Configuring Your Camera on page 25, open the product Home Page in your browser and start the
Installation Wizard. Complete the Wizard to establish the standard Security, Date and Time, Image General Layout and
Modem settings - selecting modem as your chosen method of connection.
6. Continue the configuration using the Application Wizard to define your preferred ISP and mode of operation:
choose Alarm Mode to upload single images, or upload pre/post alarm image sequences when in-image motion is
detected or when a defined alarm or time based event occurs. For information on how to create and use motion
detection windows, see Motion Detection on page 31.
7. Disconnect the AXIS 2120 from the network or Null Modem Cable and connect it directly to the modem.
8. The application setup is complete. You should now verify the configuration by triggering the defined alarm event and then
viewing the resultant images uploaded to your ISP.
Note:
Except for when the AXIS 2120 is dialing-out, you can refine or amend the product configuration
at any time using a remote dial-up connection or a local computer connected via the supplied
Null Modem Cable.
Choosing Your Application
43