Installing Your Camera To A Modem; Before You Begin - Axis 2120 User Manual

AXIS 2120 User's Manual

Installing Your Camera to a Modem

The information in this section describes how to connect the AXIS 2120 to a serial modem for
transmitting images over a normal Dial-up connection.

Before You Begin

Before you can set up and access a modem-connected AXIS 2120 from a browser, you must first
create a local connection to it. This connection is only required for the initial set up, and can be
created using the network or the supplied Null Modem Cable.
Using the Network
The easiest and best way to configure the camera for use with a modem is to first install it onto a
local network, if one is available. See Installing Your Camera on a Network, on page 12 for more
information. You can then use the Wizards and Administration tools to configure the modem
connection and the application.
Using the Null Modem Cable
When there is no network available, the alternative is to connect a local computer to the AXIS
2120 using the supplied Null Modem Cable. You then create a Dial-up connection and establish
the basic settings, using the Wizards and Administration Tools. See the following pages for more
information. This type of connection is only a temporary solution that provides initial access to the
camera. Once you have set up the camera for modem access, then all configuration can be done via
the modem connection instead and you will not need to use the cable again.
Important!
Please note that the Null Modem Cable is only intended for the initial configuration of modem applica-
tions when there is no Ethernet Network available. It is not possible to use the cable as a serial connec-
tion for using the AXIS 2120 as a "web camera".
Quick Start For Advanced Users:
Follow these abbreviated instructions if you are experienced with Windows Dial-up Networking:
1. Connect the camera to the Ethernet Network if available, and use a browser to open the
IP-address you set for your AXIS 2120. Proceed to step 5. If no network is available, use the
Null Modem Cable and proceed to step 2.
2. Set up an existing session to 115.200 bps, using the physical COM port to which you have
connected your AXIS 2120.
3. Login with the username root and the password pass. The Phone Number and Modem Type that
you enter are irrelevant at login and you should can use dummy numbers for completing these
dialogs.
Installing Your Camera to a Modem
19