Table of Contents
Advertisement
GI
FUNDAMENTAL
PROCEDURES
9MUGIX-04t
3
9MUGIX-041
9MUGIX.004
I
Depending
on location:
1. Inspection
of parts
When removed,
each part should be carefully inspected
for
malfunctioning,
deformation,
damage,
and other problems.
2. Arrangement
of parts
All disassembled
parts should be carefully
arranged
for re-
assembly.
Be sure to separate
or otherwise
identify
the parts to be
replaced
from those that will be reused.
3. Cleaning parts for reuse
All parts to be reused should
be carefully
and thoroughly
cleaned
in the appropriate
method.
REASSEMBLY
Standard
values, such as torques
and certain
adjustments,
must be strictly observed
in the reassembly
of all parts.
Refer to STANDARD
BOLT AND NUT TIGHTENING
TORQUE
in Section TD for tightening
torques not mentioned
in the main
text.
If removed,
these parts should
be replaced
with new ones:
1. Oil seals
2. Gaskets
3. O-rings
4. Lock washers
5. Cotter pins
6. Nylon
nuts
1. Sealant
should
be applied
or new gaskets
used.
2. Oil should be applied
to the moving
components
of parts.
3. Specified
oil or grease should be applied
at the prescribed
locations
(such as oil seals) before reassembly.
I
23lJGIX.004
GI-6
Hide quick links:
Advertisement
Table of Contents
