Table of Contents
Advertisement
Specifications
(*1)
For detail condition, see Section 4.1.
(*2)
Vibration applied to the HDD is measured at near the mounting screw hole on the frame as much as
possible.
(*3)
At random seek write/read and default on retry setting with log sweep vibration.
(*4)
At power-off state after installation
(*5)
Input voltages are specified at the HDD connector side, during HDD Idle state.
(*6)
Operating currents are values under random W/R operation of full partition at about 220 IOPS.
(*7)
High frequency noise (over 20MHz) is less than 100 mVp-p.
2.1.4
Error rate
Errors detected during initialization and replaced by alternate block assignments are not included in
the error rate. Data blocks to be accessed should be distributed over the disk equally.
(1)
Unrecoverable error rate
Errors which cannot be recovered within 63 retries and ECC correction should not exceed 10 per 10
bits read.
(2)
Positioning error rate
Positioning errors which can be recovered by one retry should be 10 or less per 10
2.1.5
Reliability
(1)
Mean Time Between Failures (MTBF)
MTBF of the HDDs during their life time is 1,400,000 hours (operating: 24 hours/day, 7 days/week
average DE surface temperature: 50°C or less). Continual or sustained operation at case DE surface
temperature above 50°C may degrade product reliability.
Note:
The MTBF is defined as:
MTBF =
Failure of the equipment means failure that requires repair, adjustments, or replacement.
Mishandling by the operator, failures due to bad environmental conditions, power trouble, host
system trouble, cable failures, or other failures not caused by the equipment are not considered.
24
Operating time (hours) at all field sites
The number of equipment failures from all field sites
16
8
seeks.
C141-E264
Advertisement
Table of Contents
Troubleshooting
