Messages - Panasonic DMP-BD80 Operating Instructions Manual

ROT9378
Messages
The following messages or service numbers appear on the television or unit's display when something unusual is detected during startup and use.
On the television Page
Authorization Error
- 1m:
You are trying to play the DivX VOD content that was purchased with a
26
This unit is not authorized
different registration code. You cannot play the content on this unit.
to play this title.
Cannot play. -You inserted an incompatible disc (Discs recorded in PAL video, etc.). 6, 7
Cannot display on this unit. -You tried to playa non-compatible image.
7,38
-Confirm "SO" on the unit's display is not blinking and re-insert the card.
-
No disc is inserted. -The disc may be upside down.
-
Rental Expired.
- 1m:
The DivX VOD content has zero remaining plays. You cannot play it.
26
o
This operation is not -Some operations are unsupported by the unit. For example;
20
available.
-1m:
During playback, reverse slow-motion or reverse frame-by-frame is not possible.
o
This operation is - Depending on the disc, you may not be able to perform search or skip when film
20
prohibited by this disc.
previews and warning screens are being played back.
Cannot connect. -When a hub is used but its Link lamp does not light up, check the cable
16
Please check the
connection, LAN terminal connection, cable itself (a cross over cable may be
connection of the LAN
used by mistake), etc.
cable.
IP address is not set. -The "IP Address" in "IP AddresslDNS Settings" is "---. ---. ---. ___". Set the "IP 17
Address", "Subnet Mask", and "Default Gateway". (Select the automatic address
acquisition if necessary.)
Cannot obtain IP address -If you use a hub, then check the connection between the hub and the router. 16
using DHCP.
-Use the UPLINK port of the hub to connect to a router.
Please check the
-Check whether or not the hub's Link lamp lights up. If it does not light up, then
connection or router
check the cable connection, LAN terminal connection, cable itself (a cross over
settings.
cable may be used by mistake), etc.
-If the above conditions are OK, then the router may not operate in DHCP mode.
16
Check the router settings and operation. You may reset the router to restore it to
normal.
This IP address is already in -This unit's IP address is used by another device. Check the IP addresses of this -
use.
unit, personal computers, and routers, etc. If necessary, reconfigure them to
Please check the IP address
avoid IP addresses from being duplicated.
setting.
Unable to perform -Turn the unit off. Remove the power cord and reconnect it and try again. If the
-
Connection Test.
same symptom persists, then consult your dealer.
Please try again.
IP address not set correctly.
Connection Test was -If you use a hub, then check the connection between the hub and the router.
16
unsuccessful. No reply
-Use the UPLINK port of the hub to connect to a router.
from host.
-If the hub's Link lamp does not light up, then check the cable connection, LAN
Please check the
terminal connection, cable itself (a cross over cable may have been used by
connection or router
mistake), etc.
settings.
-Check the "IP Address", "Subnet Mask", and "Default Gateway" in the "IP
17
Address/DNS Settings".
-If the MAC address information is required, then press [SETUP] to display the 17, 35
"Network" menu.
Network connection
-When you set "SO-Live Internet Access" to "Allow (Limited)" and play SO-Live
32
refused.
contents which do not have a content owner certificate, the Internet access of the
Please confirm Setup
content is not allowed. If you allow the content to connect to Internet, set "SO-Live
"SO-Live Internet Access."
Internet Access" to "Allow (ALL)".
Unable to check for latest -The firmware download server is currently unavailable. Please try again later.
-
firmware version.
Please try again later.
High Clarity Sound is -"High Clarity Sound" in setup menu is set to "Enable", and "High Clarity Sound" in
31,33
effective.
on-screen menu is set to "On".
Analog video output is
turned off when
playback starts.