Viking 3 Series Installation Manual page 10

Installation
• Note that while pushing
the dishwasher into the
cabinet, water supply
hose must move in the
channel to the front
(Figure F).
• Fix the second clip
(Figure G).
17
• After installing one clip for each
side, push the dishwasher into the
cabinet (Figure E).
Installation
18
Water supply may be connected to the
dishwasher in one of two ways:
• With metal braided hose.
• With copper tubing.
CAUTION
• Hot water supply line: Use minimum
3/8" O.D. copper tubing or metal
braided dishwasher supply line.
• Temperatures required for soldering
and sweating will damage the
dishwasher's water inlet valve so if
any such operation is needed, keep
the heat source min. 7-7/8" (20.0cm)
away from the dishwasher's water
inlet valve.
• There should not be any sharp bends
in the water line that may restrict the
water flow.
• Teflon tape or pipe thread compound
must be used for sealing the
connection. Before connecting the
copper water supply line to the
dishwasher, flush it with hot water to
clear any foreign material.
NOTICE
After connections are made, turn on the
water supply to check for leaks.