Installing The Backup Battery - Canon MV300 Instruction Manual

Installing the backup battery

Open the backup battery cover on the
battery attachment unit, and insert the
CR2025 lithium battery with the + side
facing outwards. Click the cover back
into place.
This backup battery allows the camera to
remember the date and time and other
settings when main power source is
removed. It has a life span of about a
year.
When it needs replacing (or if it has not been installed), the y mark flashes in the
display. Remove the old battery by pushing up then releasing and lifting out. Make
sure to attach a power source to the camera first, so it will remember your chosen
settings when you change the battery.
DANGER!
Treat the battery pack with care.
• Keep it away from fire (or it might explode).
• Do not expose the battery pack to temperatures greater than 60°C (140°F).
Do not leave it near a heater, or inside a car in hot weather, for example.
• Do not try to disassemble or modify it.
• Do not drop or knock it.
• Do not get it wet.
WARNING!
• The battery used in this device may present a fire or chemical burn hazard if
mistreated. Do not recharge, disassemble, heat above 100°C (212°F) or
incinerate.
• Replace the battery with a Sony, Sanyo or Panasonic CR2025, or Duracell
DL2025. Use of another battery may present a risk of fire or explosion.
• The used battery should be returned to the supplier for safe disposal.
Cautions:
• Do not pick up the battery using tweezers or other metal tools — this will cause
a short circuit.
• Wipe the battery with a clean, dry cloth to ensure proper contact.
• Keep the battery pack out of reach of children — if it is swallowed, contact a
physician immediately, as the battery case may break down and the battery
fluids damage the stomach and intestines.
• Do not disassemble, heat or immerse the battery in water, to avoid the risk of
explosion.
E
89