Installation Procedure; Removing The Tape; Installing The Toner Cartridge - Sharp DX-B350P Installation Manual

Installation Procedure

Removing the Tape

When the printer is first taken out of the packaging box, the covers of the printer are taped as
shown in the diagram. Remove the tapes. Remove the fuser locking device by pushing the tabs
as shown on the instructions at the rear of the printer.
The small lever to back of the unit is used for an optional part that is not available on this printer.
NOTE:
The lever should remain in the down position.

Installing the Toner Cartridge

When installing the Toner Cartridge, take note of the following points below:
• Never throw a Toner Cartridge into an open flame. It can cause an explosion and you can
get burned.
• Keep the toner cartridge in a location out of reach of children.
• Do not forcibly open the toner cartridge.
• Do not subject it to direct sunlight or strong light.
• When installing the Toner cartridge, select a location not subject to strong light and try to
finish the installation within 5 minutes.
• Do not touch the surface of the photosensitive drum.
• Do not stand or place the Toner Cartridge upside down. The drum might get damaged.
Installation Manual
Installation Procedure
Basic Installation
2-3