Connecting The Receiver; Switching On - Silvercrest KH 2130 Operating Instructions Manual

For the sound transmissions use, if neces-
sary, the AUDIO adapter 3,5 mm jack on
CINCH sockets 2$, which you connect to
the output of the sound card if this has
no cinch output. The yellow plug of the
CINCH—3,5mm jack cable 2) you con-
nect to the video card's video output.
Tips:
The video card must have an FBAS
output available.
Make sure that the computer is cor-
rectly configured for outputting video
on the video card.

Connecting the receiver

• Connect the Audio/Video CINCH out-
puts h of the receiver d to the A/V in-
puts on the target device, probably a
television set. For this you use the sup-
plied three core CINCH cable 2%. If
necessary, with the aid of the supplied
SCART—CINCH adapter "IN" 2!.
Note:
Be sure to match the colours correctly.
• Insert the cable plug of the second
supplied wall plug transformer 1( into
the connection socket for the supply
voltage j.
• Insert the wall plug transformer
a properly connected 230 V ~ / 50 Hz
mains power socket.
Important!
Try, if required, to operate the receiver d
in various locations to avoid cancella-
tion effects and interference and thus
improve the transmission quality.

Switching on

• Move the ON/OFF switch
of the transmitter and receiver to the
"ON" position to switch them both on.
• Switch the signal source on and, if
necessary, start playback.
• Switch the TV (target device) on and
activate the A/V inputs to which you
have connected the receiver.
• Select on the transmitter and on the
receiver, via the CHANNEL switch s
and l, implicitly in each case the
same transmission channel. The radio
transmission should now function.
Note:
The data/signals sent from the transmit-
ter are not encrypted. This means that
compatible devices within the recep-
tion range are capable of eavesdrop-
ping on the signal. The radio transmis-
sion set uses an "open standard".
• To switch the signal source AV 1 and/
or 2 for a TV connected to the trans-
mitter q press the button "ROOM 1" e
(= the room in which the transmitter is
located).
• To switch the signal source AV 1 and/
or 2 for a TV connected to the receiver
d press the button "ROOM 2" r
(= the room in which the receiver is
located).
1( into
• Point the remote control of the signal
source to the infrared receiver f of
the receiver d. The commands are
sent to your signal source.
- 8 -
a and k