Changing A Programme; Using The Delay Start Function; Using The Digital Display; Time Display - Samsung DW-UG97 Series User Manual

Changing a programme

If a programme has already started and you want to change it, follow the instructions below:
If the detergent dispenser fl ap has been opened, do not change the programme.
1. Open the door to interrupt the programme.
2. Push and hold the Start/Reset
• Once the programme is reset, the dishwasher will perform a 1 minute drain. You will be able to
change the programme once the draining ends.
• To skip the draining process, press the Power
press the button again to turn it back on.
You will have to select additional functions again.
3. Change the programme and push the Start/Reset
4. Close the door to start the new programme.

USING THE DELAY START FUNCTION

You can set the dishwasher to start a programme at a later time by choosing a delay of between 1
and 24 hours (in 1 hour increments).
1. Open the door and load the baskets.
2. Add the appropriate amount of dishwasher detergent into the dispenser and on the door (if required).
3. Push the Power
4. Select the programme and functions.
5. Set the delay time using the Delay Start
6. Push the Start/Reset
down.
7. To cancel the Delay Start function, press and hold the Start/Reset
programme.

USING THE DIGITAL DISPLAY

The digital display shows the remaining wash time, status information (Delay Start, Rinse Refi ll, and Child
Lock) and error codes.
If an error occurs while the product is operating, the code associated with the error is displayed and a
beeping sound will be played. Refer to the "Information codes" section on page 28.

Time display

The time display area indicates the time remaining until the end of the selected programme in hours and
minutes.
For detailed information on programme times, refer to the "Programme chart" section on page 29.
The time remaining may vary even with the same programme. This can be due to diff erence in water
temperature, the reactivation cycle, and the size and state of the load.
Rinse Refi ll indicator
If the "Rinse Refi ll
To refi ll the rinse aid reservoir, refer to the "Filling the rinse aid reservoir" section on page 13.
DD68-00135A_EN_130604.indd 21 DD68-00135A_EN_130604.indd 21
button for 3 seconds to reset the programme.
button to turn on the dishwasher.
button.
button. The Delay Start
" indicator is lit, it means the dishwasher is low on rinse aid and requires a refi ll.
button to turn the dishwasher off and then
button.
indicator lights up, and the clock begins to count
button for 3 seconds to reset the
Operating your dishwasher _21
2013-06-07 2013-06-07 1:42:29 1:42:29