How To Use - Sharper Image GR-T200 Instruction Manual And Warranty Information

How to Use

• You can use the trimmer to trim nose and ear hair.
• Test trimmer on a small area of your arm or
leg. If any sensitivity occurs, discontinue using
immediately. Do not use trimmer on sensitive or
irritated skin.
• Turn trimmer off before putting on or taking off
attachments or cleaning.
Trimming Nose Hair
1. Make sure nasal passages are clean
before trimming.
2. Remove the Protective Cap by pulling it
off the trimmer (Fig. 2).
3. Turn trimmer ON by pressing the
On/Off POWER button (Fig. 3).
4. Carefully insert the trimmer tip into one nostril.
CAUTION: DO NOT insert the tip more
than ¼" into nostril.
5. Slowly move the trimmer tip in and out of each
nostril to remove unwanted hair (Fig. 4).
6. For best results, make sure the side of the tip is
held firmly against the skin. This will reduce the
tickling effect that can occur.
7. Clean trimmer immediately after using.
Trimming Ear Hair
1. Clean outer area of ear and make sure it
is free of wax.
2. Remove the Protective Cap by pulling it
off the trimmer.
3. Turn the trimmer ON by pressing the
On/Off POWER button.
GR-T200_Trimmer_Diagram-01.ai 6/22/09 3:02:33 PM
GR-T200_Trimmer_Diagram-02.ai 6/22/09 3:27:21 PM
Fig. 2
GR-T200_Trimmer_Diagram-03.ai 6/22/09 3:29:06 PM
Fig. 3
Fig. 4
6
4. Pull ear flat to head with one hand and hold
trimmer with the other hand (Fig. 5).
5. Move trimmer tip around edges of ear to remove
hairs extending beyond the outer ear. Carefully
insert trimmer tip into outer ear no more than ¼".
CAUTION: To avoid injury do not put
any part of the trimmer into the ear.
Do not insert the trimmer further than
¼" into the ear as this could cause
damage to the eardrum.
6. Clean trimmer immediately after using.
Changing Trimmer Heads
There are two interchangeable blade heads. The
rotary head is recommended to trim nose hairs, and
the linear head is designed especially for ear and
eyebrow hairs.
1. First, turn the trimmer OFF.
2. Detach trimmer head by tuning it
counterclockwise to the unlocked position,
then pull off.
3. Attach the other trimmer head by turning it
clockwise into the locked position.
Cleaning Hair Reservoir
For easy cleaning, the nylon filter reservoir
stores all the hair. This is possible by the
powerful built-in vacuum.
1. First, turn the trimmer OFF.
2. Hold the trimmer upright for clean removal
of hair reservoir.
3. Detach the nose head. Remove hair stored
on the filter (Fig. 6).
GR-T200_Trimmer_Diagram-04.ai 6/22/09 3:34:05 PM
Fig. 5
GR-T200_Trimmer Head_Cleaning.aiPage 1 7/8/09 12:29:54 AM
Fig. 6
7