Roland Stika SV-15 User Manual page 31

Changing Loadable Material Width (for SV-15)
In the SV-15 model, you can change the loadable material width to match the material being loaded (360 to 381
mm (14-1/8 to 15 in.) or 280 to 305 mm (11 to 12 in.)). Change the pinch roller location and driver settings to
change the width.
–
—
Pinch-roller stopper
˜
Move the right side pinch roller to match the width of the material being loaded and attach the
pinch-roller stopper.
Pinch roller
For 280 to 305 mm (11 to 12 in.)
™
š
Load material.
p 28 "Step 1: Load Material"
For 280 to 305 mm (11 to 12 in.)
›
Change the driver cutting area to match the size of the loaded material.
Procedures 1 and 2 on page 30 "Step 2: Creating Cutting Data"
Sheet adjustment lever (right)
Sheet adjustment lever (right)
Raise the sheet adjustment lever on the right
side.
Remove the pinch-roller stopper.
Do not use excessive force to widen the opening
when removing the pinch-roller stopper. If the open-
ing is widened, the stopper may become loose and
fall out when it is next attached to the unit.
Pinch roller
For 360 to 381 mm (14-1/8 to 15 in.)
Lower the sheet adjustment lever on the right
side.
For 360 to 381 mm (14-1/8 to 15 in.)
Chapter 3: Performing Cutting
3-2 Cutting
29