Cabinet Maintenance - Pioneer S-FCRW2700 Operating Manual

Standard surround setup
This is a standard multichannel surround soundspeaker setup
for optimal 5.1 channel home theater sound.
Center
Front left
Listening position
Surround
left
NON-SKID PADS
If the front, center and surround speakers are placed on a hard
surface, such as wood or tile place four non-skid pads (small)
on the bottom flat surface of the speakers.
If the subwoofer is placed on a hard floor, such as wood or tile,
place four non-skid pads (large) on the bottom surface of the
subwoofer.
Front right
Subwoofer
Surround
right

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
then wipe again with a dry cloth. Do not use furniture wax or
cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode
the surfaces.
Wall-mounting the front and surround speaker
system
Attaching the brackets
• Make sure to tighten the supplied screw as securely as
possible when attaching the bracket to the back of the
speaker.
• Please do not attach the brackets to the center speaker.
Before mounting
• Remember that the speaker system is heavy and that its
weight could cause the wood screws to work loose, or the
wall material to fail to support it, resulting in the speaker
falling. Make sure that the wall on which you intend to mount
the speakers is strong enough to support them. Do not
mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws that are
suitable for the wall material and that will support the weight
of the speaker.
Mounting screw
(not supplied)
Bracket screw
5 to 7 mm
(supplied)
Note
• If you are unsure of the quality and strength of the walls,
consult a professional for advice.
• Pioneer is not responsible for any accidents or damage that
result from improper installation.
5 mm
10 mm
3