HUSTLER M1 Owner's Manual page 15

12
Fig. 4-8
4. Attach the recoil starter to the mower. Remove the
three existing cap screws on the cover. Align recoil
starter so that the draw cord is on the dipstick side of
the engine. Bolt recoil starter  and cover to the
engine. Route the cord through the holders provided
on the lower right hand side handle. Fig. 4-9 and
Fig. 4-10.
Cover
Existing
hardware
Fig. 4-9
Holders
Fig. 4-10
5. Place the catcher bag  onto the frame . Fig. 4-11.
Attach the catcher to the mower. Lift the guard and set
the hooks of the catcher on the housing of the mower.
To remove the catcher reverse the previous procedure.
Fig. 4-12
108548_0711
Cable harness
Loosen
11
Dispstick
Draw cord
5
WARNING: When attaching or detaching the catcher,
be sure to turn off the engine. Open or close the guard
slowly. Also, do not place your finger(s) between the
guard and the mower.
NOTE: Before operating the mower, oil and unleaded gaso-
line need to be added to the engine. Add 1.4 pints (.65 L) of
SAE 10W-30 oil and a half gallon (1.8 L) of gasoline to the
engine.
B. Mulch kit
P/N
Item
1 71906-460
2 91014-183
3 91014-182
4 11024-150
5 11086-198
6 31044-134
7 60124-220
8 31057-220
9 335L-0610
NOTE: Do not operate in conditions that cause the engine to
bog down or stall. When cutting thick grass, or high grass,
adjust the cutting height of the deck to a suitable setting. It
4-5
4
Fig. 4-11
Guard
Housing
Hook
Fig. 4-12
Description
Multi cutting blade set
Blade
Blade
Clip
Clip (stopper)
Plug
Spacer
M10 x 30 x 1.25
M6 x10 x 1.0
Qty
2
1
1
1
1
1
1
2
1