Table of Contents
Advertisement
Product installation method
Chapter 3. Product installation method
3-1. Method to adjust height of refrigerator
First adjust the level of the refrigerator.
(If the floor is uneven, the refrigerator may vibrate or cause noise.)
u Adjust the front to be leveled by turning the height adjustment screws under the front corners in the arrow direction.
3-2. Grounding method
1. In the following cases, you must always ground the refrigerator.
1) When using the refrigerator in the 110V region
2) When using the refrigerator in the 220V region where the power
outlet is not grounded to the side.
2. You must install a circuit breaker (rated current 15mA, rated
non-operating current 7.5mA) if it is difficult to ground the
refrigerator. For the circuit breaker, you can purchase and use the
one with plug and outlet.
3. For the grounding connector on back of the refrigerator, use a connecting line with a diameter of 1.6mm or longer or a
single core cord line with a nominal cross section area of 1.25mm or bigger. After soldering, bury the copper plate 75cm
or deeper from the ground.
u Size of copper plate: Thickness (0.7mm or more), area (90cm or more)
Caution
Do not ground the circuit in one of the following places:
1. Water pipe: If there is a plastic piping within the system, the ground may not be valid.
2. Gas pipe: There is a danger of fire or exposition.
3. Phone line or lightning rod: If lightening strikes, dangerous voltage may be induced in the circuit.
GR-K24PS
Horizontal adjustment leg
(lower handle part)
- 7 -
Advertisement
Table of Contents
