Service Battery; Service Hydraulic Oil - Exmark Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

3.10 SERVICE BATTERY.

3.10.1
3.10.2
3.10.3
3.10.4
3.10.5
3.10.6
3.10.7

3.11 SERVICE HYDRAULIC OIL

Machine is shipped with a dry battery.
Remove battery from machine. Tilt seat up to gain access to the battery.
Disconnect battery cables – negative (black) cable first.
Remove battery hold-down and lift battery out.
Place battery on a level surface and remove vent caps.
Fill cells with battery grade sulfuric acid (1.265 specific gravity) to halfway
between top of separators and bottom of vent well.
Battery contains sulfuric acid and may contain explosive gases.
•
Keep sparks, flames, or cigarettes away.
•
Shield eyes, protect skin and clothing when handling acid or
battery containing acid or working near such batteries.
•
Ventilate when charging or using battery in enclosed space.
•
Make sure venting path of battery is always open once battery
is filled with acid
Let battery stand for 1/2 hour after filling. If battery acid level has fallen, refill to
level above plates.
Charge the battery at 4 to 5 amps for 3-5 hours.
After charging, install vent caps and wash off any acid with water and dry battery.
Install battery in machine and secure battery hold-down. DO NOT over-tighten.
• • • •
Be sure ignition switch is "OFF" and key is
removed from ignition. Sparks could cause an
explosion or moving parts could accidentally
engage causing personal injury.
Connect battery cables - positive (red) cable first, then the negative (black)
cable and green/white wire. Slip insulator boot over the positive terminal.
NOTE: If time does not permit charging the battery, or if charging equipment is not
available, follow steps 3.9.1 through 3.9.4 and install as described in 3.9.7. Then
run the vehicle continuously for 20 to 30 minutes to sufficiently charge the battery.
After charging, if battery acid level has fallen, refill battery with clean drinking water
(distilled water is preferred – if available).
PART NO. 513747
The machine is shipped with hydraulic oil filled to the top the baffle in the reservoir.
Run the machine for approximately 15 minutes to allow any extra air to purge out of
the hydraulic system. Check hydraulic reservoir and if necessary fill the reservoir to
the appropriate level with Mobil 1 15W-50 synthetic motor oil.
www.mymowerparts.com
DANGER
CAUTION
LOCATION: Top Center of Console
Under Front of Seat
- - 15