Step 6: Apply Ac Power - NETGEAR GS716T Hardware Installation Manual

Step 6: Apply AC Power

NETGEAR GS716T,GS724T,GS748T Series Smart Switch does not have an ON/OFF
switch. The method of applying or removing AC power is by connecting or disconnecting the
power cord. Before connecting the power cord, select an AC outlet that is not controlled by a
wall switch, which can turn off power to the switch. After selecting an appropriate outlet, use
the following procedure to apply AC power.
1. Connect the female end of the supplied AC power adapter cable to the power receptacle
on the back of the switch.
2. Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC
outlet.
When applying power, the Power LED on the switch's front panel is Green.
If the Power LED does not go on, check that the power cable is plugged in correctly and that
the power source is good. If this does not resolve the problem, refer to
Troubleshooting Chart.
GS716T, GS724T and GS748T Gigabit Smart Switch
23
Table 5,