Advertisement
AV-20420
AV-20421
2.4 DISASSEMBLY PROCEDURE
2.4.1 REMOVING THE REAR COVER
(1) Unplug the power plug.
(2) Remove the 5 screws [A], and 2 screws [B] as shown in
Fig.1.
(3) Withdraw the REAR COVER toward you..
CAUTION:
When reinstalling the rear cover, carefully push it inward after
inserting the MAIN PWB into the rear cover groove.
2.4.2 REMOVING THE MAIN PWB
• Remove the REAR COVER.
(1) Raise the backside of the MAIN PWB slightly. And remove
the PWB STOPPER [C] from the cabinet bottom.
(2) Withdraw the MAIN PWB backward.
(If necessary, remove the wire clamp and connectors, etc.)
2.4.3 REMOVING THE SPEAKER
• Remove the MAIN PW board.
(1) Remove the 2 screws [D].
(2) Then you can remove the SPEAKER.
1-6 (No.52111)
2.4.4 CHECKING THE MAIN PW BOARD
(1) Pull out the MAIN CHASSIS (refer to REMOVING THE
MAIN PWB).
(2) Erect the chassis vertically so that you can easily check the
MAIN PWB from the reverse (solder) side.
CAUTION:
• When erecting the MAIN PWB, be careful so that there will
be no contacting with other PWB.
• Before turning power on, make sure that the CRT earth wire
and other connectors are properly connected.
• When conducting a check with power supplied, be sure to
confirm that the CRT EARTH WIRE (BRAIDED ASS'Y) is
connected to the CRT SOCKET PWB.
2.4.5 WIRE CLAMPING AND CABLE TYING
(1) Be sure to clamp the wire.
(2) Never remove the cable tie used for tying the wires
together.
Should it be inadvertently removed, be sure to tie the wires
with a new cable tie.
Advertisement
