Using The Built-In Flash - Canon EOS 30D Instruction Manual

Using the Built-in Flash
44l 1 A_ _BllBlH &AAM¥ _ _
E-TTL II autoflash obtains high-precision and consistent flash shots.
Using the Built-in Flash in the Basic Zone
If necessary, the built-in flash will pop-up automatically in low-light
or backlit conditions. (except in <a>
<~>
<l:Y> modes)
Using the Built-in Flash in the Creative Zone
Regardless of the light level, you can press the <
~
> button to pop-up
and fire the built-in flash whenever desired.
P :
For fully automatic flash photography. The shutter speed (11
60 sec. - 11250 sec.) and aperture are set automatically, just as
in <0> (Full Auto) mode.
Tv :
Enables you to set the desired shutter speed (30 sec. - 1/
250 sec.). The camera then automatically sets the aperture to
obtain the proper exposure at the shutter speed you have set.
Av :
Enables you to set the desired aperture. The camera then
automatically sets the shutter speed (30 sec. -1/250 sec.) to
obtain the proper exposure at the aperture you have set.
Against dark backgrounds such as the night scenes, slow-sync
shooting will be set so that both the subject and background are
exposed correctly. The main subject is exposed with the flash,
and the background is exposured with a slow shutter speed.
*
Because automatic slow-sync shooting uses a slow shutter
speed, always use a tripod.
t1t
If you do not want a slow shutter speed to be set, set C.Fn-03
[Flash sync. speed in Av mode] to [1: 1/250sec. (fixed)).
(p.168)
M :
You can set both the shutter speed (bulb or 30 sec. - 1/250
sec.) and aperture. The main subject is exposed properly by
the flash. The background exposure will vary depending on the
shutter speed and aperture.
A-DEP :
The flash result will be the same as the
<
P
>
mode.
102