NOTE:
You must connect the USB hub cable from the monitor to the computer to enable the USB
2.0 ports on the monitor. Refer to Step 4 in
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
power and signal cables are both disconnected. Also disconnect all USB cables connected to the
monitor.
1.
Disconnect and remove the signal, power, and USB cables from the monitor.
2.
Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3.
Remove the four screws from the monitor stand.
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Connecting the Cables on page
Removing the Monitor Pedestal Base
5.
11