Table of Contents
Advertisement
Getting started
Wall mount installation
The charger is ready for tabletop use. If you want to mount the
charger on a wall, use two 10mm screws and wall anchors (not
provided) to hold the charger in place. The screws and wall
anchors are available for purchase in many hardware or consumer
electronics retailers. You might need a professional to install the
charger.
To mount the charger on the wall
1. Use a pencil to mark the desired positions of the two holes on
the wall, make sure the space between the two holes is 30mm.
Drill two holes in the wall according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the
wall anchors (not provided) into the holes and tap gently on the
ends with a hammer until the wall anchors are flush with the
wall.
Screw spacing 30mm
(1.18 inches)
9
Advertisement
Table of Contents
