Electrical Connections - Panasonic CQ-DPX172U Operating Instructions Manual

Removable front panel mp3 cd player/receiver with cd changer control
Hide thumbs Also See for CQ-DPX172U:
Table of Contents

Advertisement

Electrical Connections

E
N
G
L
I
S
Cautions:
H
¡This product is designed to operate off a 12 V DC, negative ground battery system.
¡To prevent damage to the unit, be sure to follow the connection diagram below.
21
¡Remove approx.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep
cable terminals free from touching any metal parts.
¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when
the battery terminals are disconnected.
Accessory used for wiring
No.
Item
y
Power connector
❏ Wiring Diagram
Ground lead
To a clean, bare metallic part of the car
chassis.
Motor antenna
relay control lead
(To motor antenna) (Max. 500 mA)*
This lead is not intended for use with a switch actuated
power antenna.
Note: The power antenna extends automatically when
the radio mode is selected.
(White)
(White/black
stripe)
(–) (+)
Left Speaker
(Front)
30
1
/
" (5 mm) of protective covering from the ends of the leads before connecting.
4
Q'ty
1
Pre-Amp output
connector (Rear)
Antenna
y Power connector
(Black)
(Blue)
FRONT SP
(Gray/black
(Gray)
stripe)
(–) (+)
Right Speaker
(Front)
CQ-DPX172U
*Maximum current capacity of motor antenna relay control lead
and external amplifier control lead are 500 mA in total.
Pre-Amp output
connector (Front)
L (White)
R (Red)
BATTERY 15A
(Yellow)
ACC
(Red)
(Blue/white stripe)
Speaker lead
REAR SP
(Green/black
stripe)
(–) (+)
Panasonic
Left Speaker
(Rear)
(R) (Red)
CH.C-IN
(L) (White)
CD changer
control connector
Battery lead
To the car battery,
Fuse (15 A)
continuous +12 V DC
ACC power lead
To ACC power,
Resistor (1 kΩ)
+12 V DC
External amplifier control lead (Max. 500 mA)*
This lead is for connection to the power amplifier.
Note: This lead is used for power control when
an external power amplifier is connected. The
power supply of a power amplifier will be
activated when turning on the power of this unit.
(Green)
(Violet/black
stripe)
(–) (+)
Right Speaker
(Rear)
CD changer input cord
(Violet)
Panasonic

Advertisement

Table of Contents
loading

Table of Contents