Table of Contents
Advertisement
7
Powering ON
NOTICE
Before switching on the power to the PIX-4, turn on the computer.
1
Press the STANDBY key.
The STANDBY LED lights up.
8
Load the object to be scanned on the PIX-4
The sensors for the PIX-4 are highly sensitive, and can even scan three-dimensional objects made out of clay.
You can usually perform scanning if the three-dimensional object is of a composition and configuration that can retain its shape.
However, the pressures that the sensors detect are from several grams to several tens of grams, so you cannot scan objects whose shape
changes when touched by the sensors. (Pressure may fluctuate, depending on the composition of the object being scanned.)
For instance, it may not be possible to scan something like a fuzzy stuffed animal.
Maximum scanning area of the PIX-4
The maximum scanning area is shown in the figure.
The grid on the table serves as a guide for mounting the object to scan.
It does not indicate the scanning area for Dr. PICZA.
The scale is in 10-mm (3/8 in.) units.
2
152.4 mm (6 in.)
Upper surface
Front surface
Table surface
* This space cannot be scanned.
The unit performs its initialization routine, then stops.
The sound that occurs during initial operation is not
abnormal.
* When the unit is in its initialized state immediately
switching on the power, an error may be displayed
if some object touches the sensor. (When an error
has occurred, the STANDBY LED intermittently
flashes twice.)
If this happens, switch off the power, remove the
object touching the sensor, then switch the power
back on.
101.6 mm
(4 in.)
60.5 mm (2-3/8 in.)
Maximum
scanning area
10 mm (3/8 in.)
19
Advertisement
Table of Contents
