General Operating Instructions - Drill Master 67027 Set Up And Operating Instructions Manual

tool set up
From accidental
operation:
turn the trigger of the tool to
its "oFF" position and
disconnect the tool from its
battery pack before
performing any inspection,
maintenance, or cleaning
procedures.
installing the saw Blade
1. Choose the correct Saw Blade for the
material being cut. Fine tooth Saw
Blades are generally used for cutting
metal. Saw Blades with larger teeth
are generally used for cutting wood.
2. To avoid accidental injury, make sure
to wear heavy duty work gloves when
installing or removing the Saw Blade.
Blade Holder Collet
Blade
Figure 2
3. To install the blade:
a. Push in and hold the Blade Holder
Collet.
b. Insert the Blade with the teeth facing
the Guard Hinge.
c. Release the Collet.
d. Carefully pull on the Blade to make
sure it is locked in place.
4. To remove the blade:
SKU 67027
to preVent
serious injurY
Guard Hinge
For technical questions, please call 1-800-444-3353.
a. Push in and hold the Blade Holder
Collet.
b. Carefully slide the blade out of the
Saw.
c. Release the Collet.
charge the Battery
The Charger (SKU 67031) and
Rechargeable Battery Pack (SKU
67029) are sold separately. Please
refer to the 67031 Charger manual
for important safety warnings and
proper instructions on charging tool.
warning! Do NOT use a different
Charger or Battery Pack to power this
tool.

general operating instructions

• Refer to Figure 1 for the location of
the parts of the saw for the following
steps.
operating the reciprocating saw
1. Slide a fully charged Battery Pack
into the bottom of the Handle, making
sure that it clicks into place. Be sure
the Battery Pack is securely seated
into the Saw Handle so it will not fall
off during use.
2. Firmly hold the Reciprocating Saw
with both hands. Position the Blade
near the work piece, depress the
Safety Button and hold the Trigger
down. Release the Safety Button
once the tool has power. Allow the
Saw to come up to full speed before
addressing it to the work piece.
important: Do not start the Saw if the
Saw Blade is in contact with anything
before operation. If necessary, lift
Page 8