Disassembly - JVC AV-29QT4SU Service Manual

3.1 DISASSEMBLY PROCEDURE
3.1.1 REMOVING THE REAR COVER
(1) Unplug the power cord.
(2) Remove the 8 screws [A].
(3) Remove the 4 screw [B].
(4) Withdraw the REAR COVER toward you.
3.1.2 REMOVING THE BACK DOOR
• Remove the REAR COVER.
(1) Remove the 2 screws [C].
(2) Withdraw the BACK DOOR toward you.
3.1.3 REMOVING THE CHASSIS
• Remove the REAR COVER.
(1) Slightly raise the both sides of the CHASSIS FRAME by hand.
(2) Withdraw the CHASSIS FRAME backward.
(If necessary, take off the wire clamp, connectors etc.)
3.1.4 REMOVING THE MAIN PWB
• Remove the REAR COVER.
• Remove the BACK DOOR.
• Remove the CHASSIS.
(1) Remove the 6 screws [D].
(2) Remove the MAIN PWB.
[CAUTION]
If necessary, take off the wire clamp, connectors etc.
Be careful enough when developing the MAIN PWB.
3.1.5 REMOVING THE SIDE CONTROL PWB
• Remove the REAR COVER.
(1) Remove the 2 screws [E].
(2) Remove the SIDE CONTROL PWB.
3.1.6 REMOVING THE AV & HEADPHONE PWB
• Remove the REAR COVER.
(1) Remove the 1 screws [F].
(2) Remove the AV & HEADPHONE PWB.
3.1.7 REMOVING THE POWER SW PWB
• Remove the REAR COVER.
• Remove the CHASSIS.
(1) Remove the 2 screws [G].
(2) Remove the POWER SW PWB.
3.1.8 REMOVING THE LED PWB
• Remove the REAR COVER.
• Remove the CHASSIS.
• Remove the POWER SW PWB.
(1) Remove the 2 screws [H].
(2) Remove the LED PWB.
3.1.9 REMOVING THE MAIN SPEAKER & TWEETER
• Remove the REAR COVER.
• Remove the CHASSIS.
(1) Remove the 4 screws [J].
(2) Remove the MAIN SPEAKER.
(3) Remove the 2 screws [K].
(4) Remove the TWEETER.
(5) Remove the opposite side similarly.
1-4 (No.YA085C)
SECTION 3

DISASSEMBLY

3.1.10 CHECKING THE PW BOARD
• To check the back side of the PW Board.
(1) Pull out the PW Board. (Refer to REMOVING THE MAIN
PWB).
(2) Erect the PW Board vertically so that you can easily check
the back side of the PWB.
[CAUTION]
• When erecting the PW Board, be careful so that there will be
no contacting with other PW Board.
• Before turning on power, make sure that the wire connector
is properly connected.
• When conducting a check with power supplied, be sure to
confirm that the CRT EARTH WIRE (BRAIDED ASS'Y) is
connected to the CRT SOCKET PWB.
3.1.11 WIRE CLAMPING AND CABLE TYING
(1) Be sure to clamp the wire.
(2) Never remove the cable tie used for tying the wires
together.
Should it be inadvertently removed, be sure to tie the wires
with a new cable tie.