Table of Contents
Advertisement
3.
S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r C C h h a a n n n n e e l l . . Press and release the Valet/program switch
the number of times necessary to access the desired channel. Once you
have selected a channel, press and HOLD the Valet/program switch once
more. The siren will chirp and the LED will blink the number of times
corresponding to the channel that has been accessed.
NOTE: If adding a remote, a button must be taught to the unit in the Channel One or Channel
Five position prior to programming other channels.
4.
P P r r e e s s s s t t h h e e t t r r a a n n s s m m i i t t t t e e r r b b u u t t t t o o n n . . While holding the Valet®/Program switch,
press the button from the transmitter that you wish to assign to that
channel. The unit will chirp indicating successful programming. It is not
possible to teach a transmitter button to the system more than once.
5.
R R e e l l e e a a s s e e . . Once the code is learned, the Valet®/Program button can be
released
Channel Number
Function
1
Arm/Disarm/Panic
2
Silent Mode/Remote Valet/Trunk Release
3
Remote Start
4
Second unlock or other accessories
5
Arm only
6
Disarm only
7
Panic only
8
Auto-learn Standard Configuration*
9
Auto-learn Single Button Arm/Disarm Configuration*
10
Delete all transmitters
**NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
C C h h a a n n n n e e l l s s # # 5 5 - - 7 7 : : Channels 5 through 7 are used to assign the arm, disarm and panic functions to
separate buttons on the remote control. Teaching a button to Channel 5 erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed.
Similarly, if the remote is set up to use the separate arm, disarm and panic channels and a button
from that remote is entered into Channel 1, the remote will be erased from memory, and the system
will only recognize the button that was entered into Channel 1.
C C h h a a n n n n e e l l # # 1 1 0 0 : : If any button from a known transmitter is programmed to Channel 10, all trans-
mitters will be erased from memory and the system features will revert to the default settings. This
is useful in cases where the one of the customer's transmitters is lost or stolen. This will erase any
lost or stolen transmitters from the system's memory. It can also be used to start from scratch if the
transmitter buttons were programmed incorrectly.
32
Wire Color
RED/WHITE
VIOLET/BLACK
©
2002
Directed Electronics, Inc.
Advertisement
Table of Contents
Troubleshooting
