Drill Master 93440 Assembly And Operating Instructions Manual page 10

4. Slide the Battery (27) into the Charger (30) Base. The Battery can only insert one
way using the guide tabs. (See Figure E.)
5. Plug the Charger Output Cord into the Battery Charger Base.
6. Plug the Charger (30) into a 120 volt, grounded, electrical outlet.
7. Verify on the Charger (30) Base that the green power indicator light and the red
charging indicator light illuminate. If they do not illuminate, check the power con-
nection or try a different electrical outlet. (See Figure E.)
8. Charge the Battery (27) for 5 hours. Never charge the Battery for more than 5
hours or damage to the Battery and/or Drill will result. (See Figure E.)
9. IMPORTANT:
is fully charged. As a safety precaution, if the battery is being overcharged and
heats up the charger will automatically shut off to help reduce the risk of fire. This
will cause the red charging indicator light will slowly blink while the green light will
remain on. Avoid battery/ tool damage by removing power to the Charger after the
5 hour charging is finished and before the red light starts blinking.(See Figure E.)
10. When finished charging, disconnect the Charger (30) from the electrical out-
let. Disconnect the Charger Output Cord from the Charger Base. Remove the
Charger Base from the Battery (27). Then, reinstall the Battery onto the Drill.
(See Figure E.)
For technical questions, please call 1-800-444-3353.
SKU 93440
The Charger (30) will not automatically shut off when the Battery
BATTERY
(27)
CHARGER
OUTPUT CORD
FIGURE E
(See Figure E.)
(See Figure E.)
CHARGER BASE
REV 01/06
Page 10