Pre-Operation Checklist - Husqvarna FS 6500 Operator's Manual

Before leaving our factory, every machine is thoroughly tested. Follow our instructions
strictly and your machine will give you long service in normal operating conditions.
Before starting the machine, make sure that you read this entire Operations Manual and
are familiar with the operation of the machine.
WITH MACHINE COLD AND SETTING LEVEL:
Gasoline Models: Check engine oil. Fill to the full mark on dipstick with 10W30 oil, class MS, SD, SE or better.
1-2 HOUR OPERATION CHECK LIST:
ALWAYS place the machine on a level surface with the engine / motor "OFF", the
ignition switch set in the "OFF" position and disconnected from the power source before
performing any maintenance. Let the machine cool down!!
1. Check the engine air cleaner hose clamps. Tighten as required.
2. Tension the drive V-belts. DO NOT over tension!
SCHEDULED MAINTENANCE QUICK REFERENCE
Before performing any maintenance, ALWAYS place the machine on a level surface with
the engine / motor "OFF", the ignition switch set in the "OFF" position and disconnected
from the power source!

PRE-OPERATION CHECKLIST

SERVICE DAILY
:
1. Check engine oil level.
2. Check all guards for damage.
3. Check hoses and clamps for damage or looseness. Tighten or replace as
necessary.
4. Check air cleaner. Clean or replace as required.
5. Clean the machine at the end of the day.
SERVICE EVERY 50 HOURS:
1. Replace engine oil and oil filter.
2. Clean engine air fins.
3. Check V-belt tension. DO NOT over tension!
4. Clean Engine fuel bowl.
21