Nikon Coolpix P330 Quick Start Manual page 192

Using Preset Manual
Use when you want to make pictures taken under unusual lighting conditions (e.g.,
lamps with reddish-light) look as though they were shot in normal light.
Use the procedure below to measure the white balance value under the lighting
used during shooting.
1
Place a white or gray reference object under the lighting that will be
used during shooting.
2
Display the shooting menu (A64), use the
multi selector to set White balance to
b Preset manual, then press the
• The lens extends to the zoom position for
measurement.
3
Choose Measure.
• To apply the most recently measured white balance
value, select Cancel and press the k button. The most
recently measured white balance value will be set
without re-measuring the value.
4
Frame a white or gray reference object in the
reference object frame and press the k
button.
• The shutter is released and the new white balance
preset value is set (no picture is recorded).
5
Fine-tune the measured white balance value and press the k button.
• Perform fine adjustment of the measured white balance value (E33).
B
Note on Preset Manual
The camera cannot measure a white balance value for when the flash fires. When shooting with the
flash, set White balance to Auto (normal), Auto (warm lighting) or Flash.
Shooting Menu (A, B, C or D Mode)
White balance
k button.
Preset manual
Cancel
Measure
Preset manual
Cancel
Measure
Reference object frame
Auto (normal) Auto (normal) Auto (normal)
Auto (warm lighting) Auto (warm lighting) Auto (warm lighting)
Preset manual
Daylight Daylight Daylight
Incandescent Incandescent Incandescent
Fluorescent FL1 Fluorescent FL1 Fluorescent FL1
Fluorescent FL2 Fluorescent FL2 Fluorescent FL2
E35