Garrett Scorpion gold stinger Owner's Manual page 5

ASSEmBLy
Your Gold Stinger is shipped complete in
one carton. No tools are required.
1. Open the envelope which contains a
spring clip, one knob, two washers and a
threaded bold. Compress the button ends
of the spring clip and insert it, button-ends
first, into the lower stem of your detector
so that the buttons pop out of the holes.
This will enable you to adjust the length of
the overall stem.
2. Attach this lower stem to the searchcoil
by inserting the two rubber washers onto
the stem (remove paper backing and
adhere to stem). Insert the threaded bolt
through the holes of the Lower Stem and
searchcoil. Hand tighten the searchcoil
assembly with the remaining knob.
3. Using the pop-out buttons, adjust the
stem to the most comfortable length for
you.

4. Use snap locks to connect the detector
housing to the upper stem/handle.
5. Wrap the searchcoil securely around
the stem; connect to detector. The cable
should be snug but not so tight that
the searchcoil angle cannot be changed
when desired.