Before Use; Set Date And Time; Check For A Dial Tone - VTech DS6621 User Manual

Before use

After you install your telephone or
power returns following a power outage,
the handset will prompt you to set
the date and time, and the answering
system through voice guide.

Set date and time

1. Use the dialing keys (0-9) to enter
the month (MM), date (DD) and year
(YY). Then press SELECT.
2. Use the dialing keys (0-9) to enter the
hour (HH) and minute (MM). Then
to choose AM or PM.
press or
3. Press SELECT to save.
After the setting for the date and time,
the handset will display Voice guide to...
and set up Ans sys? alternatively.
Set answering system through
voice guide
This feature assists you to do the basic
setup of the answering system. You can
follow the voice guide to record your
own announcement, set the number of
rings and the message
alert tone.
1. Press SELECT to start the voice
guide for the answering
system setup. You hear the voice
prompt "Hello! This voice
guide will assist you with the basic
setup of your answering system."
2. Setup your answering system by
inputting the designated numbers as
instructed in the voice guide.
• To skip setting, press CANCEL.
Check for dial tone:
Press /HOME. If you hear a dial tone,
the installation is successful.
If you do not hear a dial tone:
• Make sure the installation procedures
described above are properly done.
• It may be a wiring problem. If you
have changed your telephone
service to digital service from a
cable company or a VoIP service
provider, the telephone line may need
to be rewired to allow all existing
telephone jacks to work. Contact your
cable/VoIP service provider for more
information.
Operating range
This cordless telephone operates with
the maximum power allowed by the
Federal Communications Commission
(FCC). Even so, this handset and
telephone base can communicate over
only a certain distance - which can
vary with the locations of the telephone
base and handset, the weather, and the
layout of your home or office.
When the handset is out of range, the
handset displays Out of range or and
no pwr at base alternately.
If there is a call while the handset is out
of range, it may not ring, or if it does
ring, the call may not connect well when
you press /HOME or
closer to the telephone base, and then
press /HOME or
the call. If the handset moves out of
range during a telephone conversation,
there may be interference. To improve
reception, move closer to the telephone
base.
9
/CELL. Move
/CELL to answer