EN 10
4.
4. Mechanical Instructions
Index of this chapter:
4.1 Dis-assembling / Re-assembling
4.1.1 Flexible Printed Circuit of Y-Buffer (Upper and Lower)
4.1.2 Flat Cable Connector of X-main Board
4.1.3 FFC and TCP from Connector
4.1.4 Exchange of LBE and LBF board - 42" SD v5
4.1.7 Exchange YB and YM board - 42" SD v5
4.1
Dis-assembling / Re-assembling
4.1.1
Flexible Printed Circuit of Y-Buffer (Upper and Lower)
•
Dis-assembly: Pull out the FPC from the connector by
holding the lead of the FPC with both hands.
•
Re-assembly: Push the lead of FPC with same force on
both sides into the connector.
Note: Be careful not to damage the connector pin during
connecting.
SDI PDP
Mechanical Instructions
Figure 4-1 Dis-assembly FPC of Y-buffer
Figure 4-2 Re-assembly FPC of Y-buffer
G_16380_012.eps
190606
G_16380_013.eps
190606