Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Avoiding Mould And Unpleasant Odours - Hotpoint RTA 42 xx Operating Instructions Manual

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
It is not sufficient to set the temperature adjustment
knobs on (appliance off) to eliminate all electrical
contact.

Cleaning the appliance

• We recommend you clean your fridge with our
Professional Fridge cleaner.To order please call us
on 08448 225 225 or visit www.hotpointservice.co.uk
• The external and internal parts, as well as the rubber
seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
• The removable accessories may be soaked in warm
water and soap or dishwashing liquid. Rinse and dry
them carefully.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic
materials which are odour free. In order to maintain an
odour free refrigerator and to prevent the formation of
stains, food must always be covered or sealed
properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors
open.

Defrosting the appliance

! Follow the instructions below.
Do not speed up the defrosting process by using any
devices or tools other than the scraper provided, you
may damage the refrigeration circuit.
Defrosting the refrigerator compartment
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
The refrigerator has an
automatic defrosting
function: water is ducted
to the back of the
appliance by a special
discharge outlet ( see
diagram ) where the heat
produced by the
compressor causes it to
evaporate. It is necessary
to clean the discharge hole regularly so that the water
can flow out easily.
Defrosting the freezer compartment
Remove frost regularly using the special scraper
provided. If the frost layer is greater than 5 mm, it is
necessary to defrost manually:
1. Set the TEMPERATURE ADJUSTMENT knob to the
position .
2. Wrap frozen foods in newspaper and place them in
another freezer or in a cool place.
3. Leave the door open until the frost has melted
completely. This can be made easier by placing
containers with lukewarm water in the freezer
compartment.
4. Clean and dry the freezer compartment carefully
before switching the appliance on again.
5. Wait for approximately 2 hours, i.e. until the ideal
storage conditions have been restored, before placing
food in the freezer compartment.

Replacing the light bulb

To replace the light bulb in the refrigerator
the cover (15W or 25W).
compartment, pull out the
plug from the electrical
socket. Follow the
instructions below.
Access the light bulb by
removing the cover as
indicated in the diagram.
Replace it with a similar
light bulb within the
power range indicated on
7
GB