Memory Operation; Storing Independent Transmit Frequencies ("Odd Splits") - Yaesu FT-1907R Operating Manual

S I
TORING NDEPENDENT
1. Store the receiving frequency using the method already described.
2. Tune to the desired transmit frequency, then press and hold in the [ D/MR ( MW )] key for
one second.
3. Within five seconds of pressing the [ D/MR ( MW )] key, use the DIAL knob or micro-
phone [ UP ] / [ DWN ] buttons to select the same memory channel number used in step 1
above.
4. Press and hold in the PTT switch, and press the [ D/MR ( MW )] key momentarily while
holding in the PTT switch. This will not cause transmission, but rather it will instruct
the transceiver that you are programming a separate transmit frequency into memory.
Whenever you recall a memory which contains independently-
stored transmit and receive frequencies, the "
will appear in the display.
The "Odd Splits" feature can store separate CTCSS/DCS functions for the receive and
transmit frequencies.
When you recall a memory channel which contains independently stored CTCSS/DCS
information, the decoder icon will appear solid, and the en-
coder icon will blink on the display.
To confirm the memorized frequency/code:
1. Press and hold in the [ MHz ( SET )] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select "14 DCS CD" when the
receiver CTCSS/DCS function is set to "DCS", or select
"52 TN FRQ" when the receiver CTCSS/DCS function is
set to "TONE SQUELCH".
3. Press the [ MHz ( SET )] key momentarily to indicate the
memorized frequency/code for the receiver.
4. Press the [ REV ( DW )] key to indicate the memorized fre-
quency/code for the transmitter. You can confirm the Trans-
mit and Receive TONE/DCS by alternately pressing of the
[ REV ( DW )] key.
FT-1907R O
PERATING
M
T
RANSMIT
M
ANUAL
O
EMORY
F
REQUENCIES "O
" indication
PERATION
S "
DD PLITS
: Receive tone/DCS
: Transmit tone/DCS
33