INSTALL SEAT (See Figs. 2 and 3)
•
Remove bolt and flat washer se cur ing seat to cardboard
packing and set aside for as sem bly of seat to tractor.
Remove the cardboard packing and discard.
•
Connect switch to seat.
•
Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
SEAT
SWITCH
PAD
SLOT
SEAT
PAN
•
Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
•
Raise seat and tighten bolt securely.
•
Remove tape and discard.
•
Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull up, slide
seat to desired po si tion and release adjustment handle.
SLOT
PAD
FLAT
WASHER
SEAT PAN
BOLT
TAB
CHECK BATTERY (See Fig. 4)
•
Lift seat pan to raised position and open battery box
door.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10
amps.
ASSEMBLY
WIRING HARNESS
Fig. 2
ADJUSTMENT
HANDLE
Fig. 3
SEAT PAN
BATTERY
BOX DOOR
TERMINAL
ATTACH HOOD SCOOP (See Fig. 5)
TAPE
TAPE
7
LABEL
TERMINAL
02021
Fig. 4
Fig. 5