Bosch Carephone 52+ Operating Manual page 34

34 en | Programming
20 Dialling modes
Ascertain whether the telephone line operates with the pulse
dialling mode (PD) or with dual-tone multi-frequency (DTMF)
dialling. You can identify DTMF by the fact that when you dial
you hear tones of different pitch in the telephone receiver.
Selecting pulse dialling will only be necessary in exceptional
cases. You can program:
23 Waiting time for repeated emergency call
This function is used to check whether a person rendering
assistance arrives promptly. An emergency call is repeated
until it is acknowledged by pressing the S button on the Care-
phone 52+. The emergency call is repeated if this time is
exceeded.
This function is only available with the Bosch RB2000 proto-
col and the Bosch advanced ANT protocol.
24 Confirmation with call
When the repeated emergency call has been acknowledged,
you can speak directly to the call centre.
You can program:
Table 12.2
F.01U.031.884 V4 | 2009.03
0 = PD
1 = DTMF
Enter a time between 0 and 99 minutes.
0 = Off.
0 = the repeated emergency call is acknowledged by
pressing the S button; a call is not made to the call centre.
1 = the repeated emergency call is acknowledged by
pressing the S button; a call is made to the call centre.
The person rendering assistance can speak to the call
centre immediately.
Operating Manual
Carephone 52+
Bosch Security Systems