ATEN CS-62A User Manual page 10

Changing the Scan Interval
Before you invoke Auto Scanning you can change the amount
of time Auto Scan dwells on each port. To do so, use the
following Hotkey combination.
[Left shift] [Right shift] [S] [n]
Where n represents a number from 1 to 4 that specifies the
desired scan interval time, as shown in the table below:
n
Scan Interval
[1]
3 secs
[2]
5 secs
[3]
10 secs
[4]
20 secs
Note: You must press and release the keys one at a time.
LED Display Table
Activity
Off Port is not selected.
On (Steady) Port is connected to an active computer.
Flashing (On and Off equal) Port is connected to an active computer and is
being accessed in Auto Scan mode.
Indication
- 8 -
2003-06-10