Husqvarna GTH220 Owner's Manual page 8

INSTALL MOWER AND DRIVE BELT (See
Figs. 5 and 7)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage park-
ing brake.
• Cut and remove tie down securing anti-sway bar.
Swing anti-sway bar to left side of mower deck.
• Slide mower under tractor with discharge guard to right
side of tractor.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES. INSTALL BELT INTO
ELECTRIC CLUTCH PULLEY GROOVE.
• Install one front link in top hole of the L.H. front mower
bracket and L.H. front suspension bracket. Retain with
two single loop retainer springs as shown.
• Install second front link in R.H. front suspension bracket
only and retain with single loop retainer spring as
shown.
• Slide right side of mower deck back and install link in
top hole of R.H. front mower bracket. Retain with single
loop retainer spring as shown.
• Turn height adjustment knob counterclockwise until it
stops.
• Lower mower linkage with attachment lift control.
• Place the suspension arms on inward pointing deck
pins. If necessary, rock and raise front of mower to
align deck pins with the holes in suspension arms.
Retain with double loop retainer springs.
CHASSIS
BRACKET
DOUBLE LOOP
RETAINER SPRING
L.H. GAUGE
WHEEL BAR
SHOULDER
BOLT
3/8-16
CENTER
GAUGE LOCKNUT
WHEEL
3/8 WASHER
ASSEMBLY
DOUBLE LOOP
RETAINER SPRING
(Inward pointing
deck pins)
ANTI-SWAY
BAR
IDLER
PULLEY
• Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
• Turn height adjustment knob clockwise to remove
slack from mower suspension.
• Raise deck to highest position.
• Assemble gauge wheels as shown using long shoulder
bolts, 3/8 washers, and 3/8-16 center locknuts. Tighten
securely.
• Adjust gauge wheels before operating mower as shown
in the Operation section of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual. Verify that the belts are
routed correctly.
SUSPENSION FRONT
ARMS LINKS
DISCHARGE
GUARD
FIG. 5
8
FRONT
SUSPENSION
BRACKETS
ELECTRIC
CLUTCH
PULLEY
SINGLE
LOOP RETAINER
SPRINGS
FRONT MOWER
BRACKET