Table of Contents
Advertisement
TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4A-4D)
•
Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away from
tractor.
•
Remove the two (2) 3/8 nuts and fl at washers from the
bolts at the tractor back plate.
DISCHARGE
CHUTE
3/8 NUT
FLATWASHER
•
Using the nuts and fl at washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
SUP PORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT
•
Install the two upper support brack ets through the back
plate and to the chas sis, install the clevis pin 10x17mm
and secure with retainer spring.
•
Assemble both support brackets to the outside of the
baggger support tube install the clevis pin 10x50mm
and secure with retainer spring.
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
CLEVIS PIN 10 X 17MM
CLEVIS PIN 10 X 50MM
SUPPORT BRACKET
13/32 FLAT WASHER
RETAINER SPRING
SUPPORT BRACKET
ASSEMBLY
FIG. 4A
FIG. 4B
FIG. 4C
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to fl oat with the
mower deck when moving on uneven terrain.
TO ASSEMBLE BAGGER (See Figs. 5 & 6)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger
to geth er.
•
Holes in front bagger tube are at an angle. Place front
bagger tube against lower bagger tube and check for
proper hole alignment before assembling bolts.
•
Assemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
Tighten se cure ly.
FRONT BAGGER TUBE
1/4 X 2"
CARRIAGE
1/4 LOCK
BOLTS
NUT
•
Slide front and lower bagger tube assembly into the
bagger assemby.
•
Assemble front and upper bagger tubes using four (4)
1/4 x 50,8mm carraige bolts and lock nuts supplied.
Tighten se cure ly.
•
Slip all the vinyl bindings over the bagger tubes
•
Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin and secure with retainer
spring.
•
Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in
order to use the handle to clear the chute in the event it
has become clogged.
8
DIS CHARGE
CHUTE
HOOK
BACKPLATE
SLOT
FIG. 4D
LOWER
BAGGER
TUBE
FIG. 5
Hide quick links:
Advertisement
Table of Contents
