Table of Contents
Advertisement
7. When the Enter New Password field opens, leave it
blank and press Enter twice.
8. In the Changes have been saved window, press Enter.
9. Press F10; then, in the Setup confirmation window,
select Yes .
How to remove the hard-disk password
Attention:
HDP has been forgotten and cannot be made available to
the servicer, IBM does not provide any services to reset
the user HDPs or to recover data from the hard-disk drive.
The hard-disk drive can be replaced for a scheduled fee.
To remove a user HDP that has been forgotten, when the
SVP and the master HDP are known, do the following:
1. Turn on the computer; then, while the "To interrupt
normal startup, press the blue Access IBM button"
message is displayed at the lower-left of the screen,
press the Access IBM button.
2. Enter the SVP. Select Start setup utility.
3. Select Security, using the cursor keys to move down
the menu.
4. Select Password.
5. Select Hard-disk x password, where x is the letter of
the hard-disk drive. A pop-up window opens.
6. Select Master HDP.
7. Enter the master HDP; then leave the New Password
field blank and press Enter twice.
8. Press F10.
9. Select Yes in the Setup Configuration window.
Both user HDP and master HDP will have been
removed.
Power management
To reduce power consumption, the computer has three
power management modes: screen blank, standby, and
hibernation.
Notes
v Screen blank mode is called standby mode in
Windows NT.
v Standby mode is called suspend mode in
Windows NT.
Screen blank mode
Screen blank mode has three variants, as follows:
If User only mode is selected and the user
Related service information
General descriptions
31
Advertisement
Table of Contents
