Table of Contents
Advertisement
SUPPORT POST (See Fig. 4)
4
Use Hardware - - GROUP "C"
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
•
Rotate cover assembly onto its side as shown.
•
Assemble support post to container support with the
three (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
SUPPORT
POST
5
MOUNTING TO TRACTOR (See Fig. 5)
Use Hardware - - GROUP "D"
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting assembly to
tractor.
•
Raise seat on tractor to allow assembly to be mounted.
•
With cover closed, lift assembly and place support post
inside mounting bracket. Allow assembly to rest on
lanced tabs of mounting bracket.
•
Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring.
•
Unlatch and open cover.
•
Install the three (3) tubing end caps onto container
support.
•
Tap each end cap onto container support tubes to seat
securely.
ASSEMBLY
LOCKNUTS
FIG. 4
BRACKET
SUPPORT PIN
END CAP
SUPPORT POST
LANCED TABS
MOUNTING
BRACKET
6
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
•
Place bottom half inside of top half, as shown.
•
Place one foot inside bottom half and lift top half to meet
bottom half.
•
Press halves tightly together while lifting top to lock into
place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
•
Repeat for second container.
8
COVER ASSEMBLY
RETAINER
SPRING
FIG. 5
Advertisement
Table of Contents
