Table of Contents
Advertisement
1
MOWER DECK BAFFLE (See Fig. 1)
Use Hardware - - GROUP "A"
•
Raise your tractor mower deck to its highest position.
•
Install the hex bolt, and locknut through mower deck
baffle and tighten securely.
LOCKNUT
MOWER DECK BAFFLE
2
REAR MOUNTING BRACKET
(See Figs. 2A, 2B & 2C)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group "B" and disregard the remaining Step 2
instructions.
LANCED TABS
TOWARD BOTTOM
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"
Only one set of hardware in GROUP "B" will be used to mount
the rear mounting bracket. To determine which set is correct
for your tractor, check to see if there are (2) two upper corner
ribs on each side of drawbar. If your tractor has the upper
corner ribs, use the (4) four self tapping shoulder bolts. If your
tractor does not have the corner ribs, use the set of (4) four
bolts and locknuts.
SELF TAPPING SHOULDER BOLTS (See Fig. 2B)
•
Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
•
Hang the mounting bracket, lanced tabs towards bottom,
on the bolts.
ASSEMBLY
HEX BOLT
FIG. 1
SHOULDER
BOLTS
FIG. 2A
UPPER CORNER
RIBS
SELF
TAPPING
SHOULDER
BOLTS
BOLTS AND LOCKNUTS (See Fig. 2C)
IMPORTANT:
O N T R A C T O R S W I T H F U E L T A N K
UNDER THE SEAT, THE DRAWBAR MUST BE REMOVED
FOR INSTALLATION OF MOUNTING BRACKET. TO
REMOVE DRAWBAR, REMOVE TWO HEX BOLTS ON
BOTH SIDES OF DRAWBAR.
•
Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller inside holes on the
drawbar.
NOTE: If your tractor drawbar does not have the four correct
holes for mounting the bracket, refer to the PREPARATION
section of this manual.
•
Install the four bolts and locknuts as shown and tighten
securely.
•
If drawbar was removed from tractor, reassemble to
tractor at this time. Tighten securely.
LOCKNUTS
3
COVER SEAL (See Fig. 3)
No hardware required
•
Align mark on seal with mark at cover opening.
•
Work seal into opening so cover sits between flanges of
seal.
ALIGNMENT
MARKS
7
UPPER CORNER
RIBS
LANCED TABS
TOWARD BOTTOM
FIG. 2B
BOLTS
DRAWBAR
MOUNTING
BOLTS
(BOTH SIDES)
LANCED TABS TOWARD BOTTOM
FIG. 2C
COVER SEAL
FIG. 3
Advertisement
Table of Contents
