Sunroof - GMC Sierra 2005 Owner's Manual

To clean the tonneau cover, use mild soap and water.
If necessary, use a soft bristle brush to remove dirt
trapped in the grain of the material.

Sunroof

The vehicle may be equipped with a power sliding
sunroof. To open or close your sunroof, the ignition
must be on or Retained Accessory Power (RAP) must
be active. See Retained Accessory Power (RAP)
on page 2-23 for more information.
4. To add cargo to the
box, remove all bows
and the back rail
and stow them safely.
To close the sunroof, press and hold the front of the
control. The control must be held until the glass
stops moving, so that the sunroof will be fully seated.
The sunroof also has a roller sunscreen that can
be used to block the rays of the sun. The roller
sunscreen can be manually operated with the sunroof
in an open or closed position. To open the sunscreen,
press up to unlatch it and roll it back. To close, pull
it forward and latch it to the close position.
Do not leave the sunroof open for long periods of
time as debris can collect in the tracks.
If the battery has been recharged, disconnected, or not
working, the sunroof may need to be reprogrammed.
To do this, start the vehicle and press forward on the
sunroof control until it moves to a fully closed position.
This resets the sunroof memory, enabling the sunroof
to function properly.
The sunroof control is
located on the overhead
console. Press the
rear of the control to open
the sunroof to the vent
position, then press
the rear of the control
again to express-open
the sunroof.
2-77