Chrysler Town & Country 2011 Owner's Manual page 34

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
• For vehicles not equipped with the Keyless Enter-
N-Go feature, the ignition switch must be in the
ON/RUN position in order to drive the vehicle.
• For vehicles not equipped with the Keyless Enter-
N-Go feature, the message "Remote Start Active —
Key To Run" will display in the EVIC until you insert
and turn the key to ON/RUN position. Refer to
"Electronic Vehicle Information Center (EVIC)" for
further information.
• For vehicles equipped with the Keyless Enter-N-Go
feature, the message "Remote Start Active — Push
Start Button" will display in the EVIC until you push
the START/STOP button.
Cancel Remote Start
Remote Starting will also cancel if any of the following
occur:
• The engine stalls or engine speed exceeds 2500 rpm
• Any engine warning lights come on
• Fuel lamp turns on
• The hood is opened
• The hazard switch is pressed
• The shift lever is moved out of PARK
• The engine is allowed to run for the entire 15-minute
cycle
To Turn Off The Engine While In Remote Start
Mode
Press and release the REMOTE START button one time or
allow the engine to run for the entire 15 minute cycle.
NOTE: To avoid unintentional shutdowns while in the
Remote Start Mode, the system will not allow the Remote
Start button to shut down the engine for two seconds
after receiving a valid Remote Start request.