2Nd-Row Bucket Seats; Memory Settings; Automatic Climate Controls - Hummer H2 2009 Getting To Know Manual

Continue to press the desired button to
cycle through the temperature settings
of High (three indicator lights), Medium
(two indicator lights), Low (one indicator
light) and Off (all indicator lights are off).
Heated seat operation is canceled each
time the ignition is turned off.
2nd-Row Heated Seats
Press the (Heated Seat) button,
located on the rear control panel on the
back of the center console, to turn on
each heated rear seat and cycle through
the temperature settings.
See Section 1 of your Owner Manual

2nd-Row Bucket Seats

(if equipped)
To recline the 2nd-row bucket seats,
lift the lever on the outboard side of
the seat and move the seatback to the
desired position; then release the lever.
See Section 1 of your Owner Manual.

Memory Settings

Memory settings can be programmed for
the position of the driver's seat and out-
side mirrors for two drivers. The memory
buttons are located on the driver's door.
To save memory settings:
1. Adjust the driver's seat and outside
mirrors to the desired position.
2. Press and hold button 1 or 2 until two
beeps sound.
3. Repeat these steps for a second
driver using the other memory button.
To recall the settings, press memory
button 1 or 2 with the vehicle in Park.
The memory settings also can be
programmed with the DIC to be recalled
automatically when using the Remote
Keyless Entry transmitter.
Easy Exit Seat
With the vehicle in Park, press the
(Easy Exit Seat) button to recall the exit
position for the driver's seat. The easy
exit seat setting also can be pro-
grammed in the DIC to be recalled
when removing the key from the ignition.
See Section 1 of your Owner Manual.

Automatic Climate Controls

The automatic climate control system
maintains the desired individual temper-
ature for the driver and front seat pas-
senger. The system adjusts the airflow
mode, fan speed, air conditioning and
recirculation functions to reach the set
temperature(s) as quickly as possible.
Automatic Operation
To set the automatic mode:
1. Press the AUTO button.
2. Set the driver's and front passenger's
temperature using the + or – temper-
ature buttons.
Manual Operation
To operate the system manually, use the
following controls:
(On/Off): Press this button to turn the
system on or off.
(Fan): Press the up or down arrow
to increase or decrease fan speed.
7