Table of Contents
Advertisement
Universal Garage Door Opener (If Equipped) 141
Fixed Code Programming
Note: It may be helpful to have another person assist you in
all the switch settings from left to right.
When the switch is in the up, on, or + position, mark down "left button".
When the switch is in the middle, neutral, or 0 position, mark down
"middle button".
When the switch is in the down, off, or – position, mark down "right
4. Enter the corresponding DIP switch settings from left to right into the
system by pressing and releasing the buttons corresponding to the
settings you noted.
5. Simultaneously press and release all three function buttons. The LED
7. When the garage door moves, release the button within one second.
When the button is released, the LED lamp will flash slowly.
8. The LED lamp will begin to flash rapidly until programming is
complete. If your garage door does not operate, repeat the previous
steps. Otherwise, call the toll-free help line at 1-866-572-2728.
2014 05+ Mustang (197)
Owners Guide gf, 3rd Printing, January 2014
USA (fus)
programming the transmitter.
To program units with fixed code
DIP switches, you will need the
garage door hand-held transmitter,
paper and a pen or pencil.
1. Switch the ignition on.
2. Open the battery cover and note
button".
3. Press all three function buttons
simultaneously for a few seconds
and then release. The LED lamps
will flash slowly.
Note: The following step must be
completed within 2.5 minutes.
lamps will illuminate.
6. Press and hold the function
button you would like to use to
control the garage door.
Note: You may need to hold the
button from 5–55 seconds before
observing movement of the garage
door.
Advertisement
Table of Contents
