Cable Flag; Patch Panel - Brother P-Touch PT-E550W Quick Setup Manual

CABLE FLAG

Labels printed with this mode can be wrapped around a cable
or wire, and both ends of the label stick together to form a flag.
The text on flag labels is printed on both ends of the label,
leaving a blank space in the middle that wraps around the
cable. In this mode, you can specify the following items.
• Layout: (The same text is printed on each
block.),
(Two different texts are printed on each block.)
• Flag Length: 1.2" (30 mm), 0.4" (10 mm) - 8.0" (200 mm)
• Cable Diameter: 0.25" (6 mm), 0.12" (3 mm) - 3.50" (90 mm)
• Orientation:
Horizontal
• You can enter up to two bar codes when
• We recommend using Flexible ID Tape for Cable Flag labels.
• Labels made with Flexible ID Tape are not designed for use as electrical insulation.

PATCH PANEL

Labels printed with this mode can be used to identify various
types of panels. In this mode, you can specify the following
items.
• Block Length: 0.60" (15.0 mm), 0.20" (5.0 mm) - 12.00"
(300.0 mm)
• # of Blocks: 4, 1 - 99
• Separator:
(Bold),
• Orientation:
• Reverse: Off, On
• Advanced: Off, On
Adjust block length independently when "Advanced" is set to "On".
• No Margins: Off, On
Set the left and right label margins to zero.
"Advanced" and "No Margins" cannot be set to "On" at the same time.
(Horizontal),
Flag Cable Flag
length circum- length
ference
(Tic), (Dash),
(Frame),
(Horizontal),
1A-B01 1A-B02 1A-B03
Block length Block length
1. Flag at least 0.2" (5 mm)
(Vertical)
Vertical
Flag Cable
length circum-
ference
is selected in flag layout.
(Line),
(None)
(Vertical)
Block length
Selecting a Labeling Application Type
1
Flag
length
37