Adjusting The Power Tool Prior To Use; Practical Applications - Hitachi C 10FCH2 Handling Instructions Manual

Laser Marker (Only C10FCH2)
6 mm Wing Bolt
Vise Assembly
(2) During bevel and compound cutting, attach the dust bag
at a right angle to the base surface as shown in Fig. 3.
Dust bag
Duct
Right angle
CAUTION
Empty the dust bag frequently to prevent the duct and
the lower guard from becoming clogged.
Sawdust will accumulate more quickly than normal
during bevel cutting.
6. Installation
Ensure that the machine is always fixed to bench.
Attach the power tool to a level, horizontal work bench.
Select 8 mm diameter bolts suitable in length for the
thickness of the work bench.
Bolt length should be at least 35 mm plus the thickness
of the work bench.
For example, use 8 mm × 60 mm bolts for a 25 mm
thick work bench.

ADJUSTING THE POWER TOOL PRIOR TO USE

CAUTION
Make all necessary adjustments before inserting the
plug in the power source.
Gear Case
Dust Bag
Turn Plate
Sub Fence (B)
Fence (B)
Base
Fig. 3
Motor
Lock lever (C) (For Australia)
Head
Handle
Motor
Saw Blade
Lower Guard
Turntable
Fig. 2
1. Check to see that the lower guard operates smoothly
CAUTION (For Australia)
This compound miter saw is equipped with a saw
head lock as safety device.
To lower the saw head to cut, the lock must be released
by pressing the lock lever (C) with your thumb.
(1) When you push down the handle while pushing the
lock lever (C), check that the lower guard revolves
smoothly (Fig.4).
(2) Next, check that the lower guard returns to the original
position when the handle is raised.

PRACTICAL APPLICATIONS

WARNING
To avoid personal injury, never remove or place a
workpiece on the table while the tool is being operated.
Never place your limbs inside of the line next to
warning sign while the tool is being operated. This
may cause hazardous conditions (see Fig. 5).
Indicator (B) (For bevel scale)
Fence (A)
Table Insert
Indicator (A) (For miter scale)
Lever
Side Handle
Lock lever (C) (For Australia)
Lower Guard
Fig. 4
5